Embroidery file “FSL - Pine cone/Pineapples-3D” --- Design Pack

All embroidery files in the store have been extensively tested by me and my embroidery fairies and are error-free. However, if you encounter any problems, please contact me.

•     I recommend using 3 layers of washable stabilizer for FSL (free standing lace).
•     Please DO NOT use foil.
•     The speed of the embroidery machine should always be drastically reduced.
•     Always use the smallest possible hoop, this is the best way to ensure good tension of the stabilizer.
•     I recommend using a 90 topstitch needle and embroidering at a moderate speed.
•     It is also advantageous NOT to embroider several elements in one large frame, but always individually in the smallest possible frame.  

 
After embroidering, rinse the stabilizer under lukewarm running water and lay your pieces flat to dry. Under no circumstances should you stretch or tug your embroidery pieces while wet. You are welcome to steam iron them under a dish towel when they are dry.
 

Rahmengröße	Datei	Motivgröße/mm (inch)	Stiche	Farben	Garnwechsel
	Minizapfen-10	10,6x10,6 (0.42x0.42)	360	1	0
	Minizapfen-15	15,3x15,3 (0.60x0.60)	579
	Minizapfen-18	18,3 x18,2 (0.72x0.72)	738
	Minizapfen-20	20,3x20,2 (0.80x0.80)	861
	Minizapfen-23	23,4x23,2 (0.92x0.91)	1037
	Minizapfen-26	26,4x26,2 (1.04x1.03)	1195
	Minizapfen-29	29,4x29,2 (1.16x1.15)	1463

All products can be downloaded immediately after payment.
This is an embroidery file and not a finished embroidered motif!