Embroidery file “FSL - 3D-Gerbera” --- Design Pack

I provide the files in dst, exp, hus, jef, pes, vip, vp3 and xxx format.

All embroidery files in the store have been extensively tested by me and my embroidery fairies and are error free. However, if you encounter any problems, please contact me.

    I recommend using 3 layers of washable stabilizer for FSL (free standing lace).
    Please DO NOT use foil.
    The speed of the embroidery machine should always be drastically reduced.
    Always use the smallest possible hoop, so a good tension of the fleece is best given.

I recommend using a 90 topstitch needle and embroidering at a moderate speed. It is also advantageous NOT to embroider several elements in one large frame, but always individually in the smallest possible frame.
TIP: Do not throw away scraps from the stabilizer. Put strips left over from other lacework between 2 layers, so you have your 3 layers. This is money and material saving.
 
After stitching, rinse the stabilizer under lukewarm running water and lay your pieces flat to dry. Under no circumstances should you stretch or tug your embroidery pieces while wet. You are welcome to steam iron them under a dish towel when they are dry.
 

Datei	Motivgröße/mm	Stichanzahl	Farben	Farbwechsel
Blatt	67,4 x 118,8	10111	2	2
Blatt-uni	67,4 x 118,8	10116	1	1
Gerbera-A-80	79,9 x 79,9	11200	1	1
Gerbera-B-80	69,9 x 69,9	9590	3	3
Gerbera-B-80-2	69,9 x 69,9	10201	4	4
Stempel-Stiel	20,6 x 113,4	1039	1	1

All products can be downloaded immediately after payment. This is an embroidery file and not a finished embroidered motif!